• Back To Bondtech Shop
  • |
  • About
  • News
  • Where To Buy
  • Become a Partner
  • Firmware & More
DDX for Creality
Contents
  • Adjusting The Extruder Stepper Motor Current
  • Guides Implementation
Bondtech Step By Step Guides

Site Navigation

  • Guides
  • Bondtech Main
  • Creality3D
DDX for Creality

DDX for Creality

Group of Guides on installing a DDX on a Creality 3D printer.

4 Categories

CR-10S
CR-10S
CR-10S Pro
CR-10S Pro
Ender-3
Ender-3
Ender-5
Ender-5

How-to Guides

00. Changing Machine Settings

00. Changing Machine Settings

01. Mechanical Installation of a BL Touch levelling sensor

01. Mechanical Installation of a BL Touch levelling sensor

03. How to Install The DDX Thermistor Adapter

03. How to Install The DDX Thermistor Adapter

04. Replacing Creality CR-10S Pro Hotend With Copperhead™

04. Replacing Creality CR-10S Pro Hotend With Copperhead™

05. Creality 3D CR-10S Pro - Stepper Current Adjustment

05. Creality 3D CR-10S Pro - Stepper Current Adjustment

06. Stepper Current Adjustment On CR-10S

06. Stepper Current Adjustment On CR-10S

In this category we will have information on how to install and upgrade Creality Ender and CR models with the Bondtech DDX Direct Drive eXtruder for Creality.

Adjusting The Extruder Stepper Motor Current

The stepper motor we supply with the Bondtech DDX Direct Drive eXtruder must be fed with up to 0.7A. Creality extruder stepper motors are usually fed with more than 1A. We recommend lowering the current to avoid overheating the stepper motor. See how to adjust the current on the guides we supply above. On Ender-3 the current will be around 0.72A. Low enough. No change required. But do check if you can.

Guides Implementation

We will present here guides implemented on the following 4 models:

  • Ender-3;
  • Ender-5;
  • CR-10S;
  • CR-10S Pro.

For additional models, we ask users to adapt the procedures presented.

Products
  • Products
  • Upgrade Kits
  • Extruders
  • Accessories
  • Spare parts
Bondtech
  • About
  • News
  • Where To Buy
  • Become a Reseller or OEM Partner
  • Customer Service
Customer Service
  • FAQ
  • Github
  • Support
  • Terms & Conditions
  • Privacy Policy


©2022 Bondtech AB. All rights reserved.
Bondtech© and BMG© are Registered Trade Marks of Bondtech AB