00. Changing Machine Settings
In this category we will have information on how to install and upgrade Creality Ender and CR models with the Bondtech DDX Direct Drive eXtruder for Creality.
Adjusting The Extruder Stepper Motor Current
The stepper motor we supply with the Bondtech DDX Direct Drive eXtruder must be fed with up to 0.7A. Creality extruder stepper motors are usually fed with more than 1A. We recommend lowering the current to avoid overheating the stepper motor. See how to adjust the current on the guides we supply above. On Ender-3 the current will be around 0.72A. Low enough. No change required. But do check if you can.
We will present here guides implemented on the following 4 models:
- CR-10S Pro.
For additional models, we ask users to adapt the procedures presented.