Introduction
Product Page
This Guide relates to the Bondtech DDX Thermistor Adapter:
https://www.bondtech.se/en/product/therm...
Know more about the DDX here:
About the DDX Direct Drive eXtruder for Creality
Applies to
This guide is being illustrated with a Creality CR-10S Pro, but it applies to all other models the DDX is compatible with:
Ender-3 | Ender-3 Pro | |
Ender-5 | Ender-5 Pro | |
CR-10 | ||
CR-10S | CR-10 S4 | CR-10 S5 |
CR-10S Pro | CR-10S Pro V2 | CR-10 Max |
You will need
Tools
Parts
No parts specified.
-
-
-
Drag the paste inside to one end of the bag.
-
Cut the other end of the bag with the scissors.
-
Push material to the cut edge.
-
-
-
Dip the thermistor inside the bag.
-
Coat it with a thick layer of thermal paste.
-
-
-
Insert the coated thermistor into the cartridge.
-
Slowly rotate the cartridge back and forth while inserting the thermistor.
-
Push it in until it hits the limit inside the cartridge.
-
-
-
Use the paste bag as brush.
-
Spread thermal paste on the outside of the cartridge.
-
-
-
Unscrew the holding screw.
-
Insert the cartridge in the 3mm hole.
-
Push it all the way until it flushes on the other end.
-
-
-
Coat the external surface of the heater cartridge with thermal paste.
-
Insert it in the 6mm hole.
-
Push it all the way in until it flushes on the other end.
-
-
-
Spread apart the 2 thermistor wires.
-
Insert the holding screw in between the 2 wires.
-
Screw it in until it holds the wires and cartridges in place.
-