Introduction
Product Page
This Guide relates to these Prusa i3 Upgrade Kit:
https://www.bondtech.se/en/product-categ...
Bondtech specific changes:
You can read about all the changed made to the firmware here:
https://www.bondtech.se/en/2019/09/12/fi...
Compatibility
The firmware is compatible with the following machines:
Prusa i3 MK2.5 |
Prusa i3 MK2.5S |
Prusa i3 MK3 |
Prusa i3 MK3S |
-
-
Reconnect the Power Cable
-
Turn the printer ON.
-
-
-
Locate the printer USB port
-
And connect it to your computer using a USB cable.
-
-
-
Open Prusa Slicer
-
Use the "Configuration" -> "Flash printer firmware" option
-
Locate the file you previously downloaded and uncompressed.
-
Select the Serial Port connecting to your printer and press Flash!
-
-
-
The Firmware Flasher will perform the update process.
-
Wait for the process to complete until the "Flash succeeded!" message shows in your screen.
-
The installation is almost done.
2 things are missing before you are ready to print:
- Perform a Factory Reset;
- We recommend to use a proper end script with at least 10mm filament retraction before the heater is turned off to avoid heat creep and filament jamming the hotend in between prints.
The installation is almost done.
2 things are missing before you are ready to print:
- Perform a Factory Reset;
- We recommend to use a proper end script with at least 10mm filament retraction before the heater is turned off to avoid heat creep and filament jamming the hotend in between prints.