Skip to main content

List of the Setup Guides available to help users of our upgrade kits for Makerbot 3D printers

1 Questions View all

Extruder is not working post install

So did all the steps for install including the software section and the extruder is not functioning. The motor is jittering back and forth and not pushing the filament.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi, this normally is an indication that one or more wires have a bad connection so both coils in the steppermotor is not energized. Check so that the wires are ok and so that the crimping contacts have not moved in the connector housing.

Was this answer helpful?

Score 0
Add a comment

Add your answer

timothy f fairbanks will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 36