Skip to main content

Here you can find the most frequent question we receive from our community members, grouped by category.

20 Questions View all

Max retraction setting for CR-10S Direct Drive Kit

  1. What is the maximum recommended retraction setting for the CR-10S direct drive kit?
  2. What is the maximum recommended retraction speed for the CR-10S direct drive kit?
  3. What do you recommend if stringing is still occurring at the maximum recommended settings?
Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

1 Answer

Hi, we recomend to use a max retraction setting lenght of 4 mm, but normally with regular PLA 1.1mm is sufficient. As for the retraction speed we recomend to use max 40 mm/sec, normally using 30 mm/sec is sufficient.

If you still are having problems try another filament, check so that the nozzle is ok and check the PTFE guide tube that goes into the hotend.

Was this answer helpful?

Score 0
Add a comment

Add your answer

davi will be eternally grateful.
View Statistics:

Past 24 Hours: 4

Past 7 Days: 11

Past 30 Days: 22

All Time: 22