Skip to main content

Here you can find the most frequent question we receive from our community members, grouped by category.

20 Questions View all
Discussion Topic

Print settings for Prusa MK3s Bondtech upgrade x-carriage

Are there any recommendations regarding the print settings for the MK3s x-carriage - for a good balance between weight and rigidity of the printed part (PETG)?

Many thanks in advance.

Tiemo

Reply to discussion Subscribe to discussion

Is this a worthwhile discussion?

Score 0
Add a comment

2 Replies

Most Helpful Answer

Hi, use 3 perimeters, 40% infill and 0.25 mm layerheight.

Was this reply helpful?

Score 1

Comments:

Thank you very much for the super fast response :-) I'll try that!

by

Add a comment

You are welcome Tiemo!

Was this reply helpful?

Score 0
Add a comment

Join the discussion

Tiemo Benjamin Esser will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 18