Skip to main content

NOTICE: All user accounts will be disabled by 20/02/2020. See why here.

Discussion Topic

not extruding and clicking duet

Hi, support I have a CR10S with a Duet Wifi board I finish my upgrade with Bondtech and e3dv6, after sometime working I start to get several problems with my prints, I lisent a clicking or clock noise from BMG side and this ruin my print. Nozzle is clean and newbrand…

Block Image

check the video

Reply to discussion Subscribe to discussion

Is this a worthwhile discussion?

Score 0
Add a comment

1 Reply

What is your setting of the thumbscrew adjuster? For hard filamnts we recomend to tighten fully and then back it off 1.5-2 turns.

Was this reply helpful?

Score 0


Thanks Martin, for your quick reply, finally are change my S3D retractions to lowest retractions settings and works fine.



@drslump Great to hear that you sorted it out! Happy printing!


Add a comment

Join the discussion

DrSlump will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 27